Custom Granite and Marble Designs Raleigh

I need an in-line boring machine to drill shelf holes in custom cabinets?

rocknrod04


The question says I need one , sorry about my punctuation . Everyone makes a mistake now and then
I am not hanging shelves on the wall , I am manufacturing cabinets .

This entry was posted on Saturday, August 18th, 2007 at 6:19 am and is filed under custom cabinets. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

3 Responses to “I need an in-line boring machine to drill shelf holes in custom cabinets?”

1. Xavier Says:
   August 19th, 2007 at 4:52 pm

   ok now this is better

   I think I found it here

2. leo Says:
   August 22nd, 2007 at 2:39 am

   Use a impact drill with tungsten carbide drill for concrete.Mark out the hole or have the shelf on position by holding and mark out the hole.Use either drop on anchor or anchor bolt,available at any hardware store normally size 3/8” diameter

3. Cap'n Donna Says:
   August 23rd, 2007 at 3:24 am

   yes, the inline boaring machine is the better choice for precision….if you are totally confident on your precision drilling abilities, go ahead and use a regular drill and different bits, but pay very close attention…one wrong hole will screw up an entire cabinet…

Leave a Reply

You must be logged in to post a comment.